Type of glue required:

Glue – A system where both coats are made of animal glue is used when the strength of the bond is not an important factor, such as with lightweight papers and materials. Phenolic Resin – This system uses

Yes.FREE SAMPLES 5kg can be provided for your evalution.

We are a manufacturing and trading combo,produce and export fused alumina for more than 10 years.

When functionalising fused alumina, a very thin layer of a silane adsorption group is applied to the fused alumina particles. This organic surface coating has the effect of better embedding and increased scratch resistance in a melamine resin

Corundum is a mineral from the category of oxides and hydroxides and is the most frequently used industrial mineral worldwide. It also occurs naturally as a gemstone (sapphire, emerald, ruby). Chemically corundum is aluminium oxide with the chemical

The description of the grain shape can range from “angular” to “acicular” to “spherical”. When the value of the dimensionless form factor is 1, the grain is spherical. The smaller the form factor, the pointier the grain.

Silicon carbide is a chemical compound of silicon and carbon and belongs to the group of carbides. The chemical formula is SiC.Silicon carbide is at the same time the hardest and lightest ceramic material and is also highly

MicroBlasting is extremely efficient and precise, so it is hardly likely you will need to recycle abrasive, but it is important to know the risk involved. Unlike grit or bead blasting, a MicroBlasting system can only cycle abrasive

Structure is basically the spacing between abrasive grains.  An open structure would be 12 or higher while a closer structure would be 6 or so.  Here again, the structure depends on a variety of factors not the least

If you are roughing, choose a 36 to 80 grit. If you are intermediate grinding, use 80 through 180 grit. If you are finishing, use 220 through 240 grit.

A typical grinding wheel specification consists of the grit type, the grit size, the hardness, the structure and the bond.  A typical grinding wheel specification would be A60-I10-VS.  ‘A’ is the grit type (aluminum oxide), ’60’ is the

Grit size typically runs from coarse (16 -24 grit), medium (36 – 60 grit) and fine (80-120 grit).  Superfine grits run from 150 and higher.  Grinding wheels usually will be between 24 and 100 grit.  Honing stones and

Moisture contamination is the number one reason customers call Technical Support. Fortunately, it is usually preventable. There are 4 key ways to keep your abrasive free of moisture:1.Store abrasive properly and always make sure bottles are tightly closed