Can you produce according to the samples?

Silicon carbide (SiC) is produced from coke and quartz sand applying the Acheson process in an electric resistance furnace. When petrol coke and quartz sand are grouped around a graphite electrode and heated to a temperature of 2,000°C,

When functionalising fused alumina, a very thin layer of a silane adsorption group is applied to the fused alumina particles. This organic surface coating has the effect of better embedding and increased scratch resistance in a melamine resin

Moisture contamination is the number one reason customers call Technical Support. Fortunately, it is usually preventable. There are 4 key ways to keep your abrasive free of moisture:1.Store abrasive properly and always make sure bottles are tightly closed

Raw materials containing aluminium oxide are electrothermally melted at a reaction temperature of more than 2,000 °C to produce the various fused aluminas. Different starting materials are used depending on the desired type of fused alumina. For instance,

An abrasive’s shape, hardness, and particle size really determine the effectiveness of a MicroBlasting application. Each application is unique, and abrasive selection depends on the composition of the targeted part and the application’s desired result. See our Abrasive Media

Mohs hardness (according to Friedrich Mohs, 1773 – 1839) ascribes a relative hardness value to certain known minerals on a scale ranging from 1 (talc) to 10 (diamond). Accordingly, a mineral is considered harder than another if it

Grain – a synthetic or natural abrasive; Bond – an adhesive that permanently bonds the backing to the abrasive; Backing – a backing that the abrasive is bonded to

Glue – A system where both coats are made of animal glue is used when the strength of the bond is not an important factor, such as with lightweight papers and materials. Phenolic Resin – This system uses

The specific surface means the outer surface of a substance including all accessible pores in relation to the mass. It is determined using the Brunauer-Emmett-Teller (BET) method.

Hardness is rated from A-Z with ‘A’ being the weakest bond and ‘Z’ being the strongest.  A weak bond is preferred for grinding harder materials while  a stronger bond is desired for softer materials.  A typical weak bond

Grit size typically runs from coarse (16 -24 grit), medium (36 – 60 grit) and fine (80-120 grit).  Superfine grits run from 150 and higher.  Grinding wheels usually will be between 24 and 100 grit.  Honing stones and

The flow behaviour of powders depends on many factors. The following applies in general: Coarser, dry grain types flow easily, but the fine the grains get, the stronger is the impact of morphology and various adhesive forces on

Abrasive grains – usually aluminum oxide or silicon carbide Bonding agent – usually a resin bond Spacing of grains within the bond – determine porosity and strength

The specific weight is the ratio of the weight of a body to its volume. The specific weight of corundum under normal conditions is 3.94 g/cm3.

The best way to have abrasive products retain maximum performance and work life is to store them properly. The bonding and backing materials used in abrasives are very sensitive to changes in temperature and humidity. Abrasives are best

We are a manufacturing and trading combo,produce and export fused alumina for more than 10 years.